Film Installation Steps

1. The first step is to separate the film and attached line from the clear cap sheet.		2. Spray the painted surfaces where the film will go with soap solution.
3. Remove the white liner from the film, and spray the exposed adhesive with soap solution.		4. The film is then positioned on the car and the top side is sprayed with soap solution.
5. The next step is to spray water-alcohol solution under the film at the starting position.		6. Then Squeegee the film down at that start position to tack it in place.
7. Spry the outside of the film again with the soap solution.		8. Then squeegee the film from the start position upwards and outwards toward the edges.
9. Stretching the film with the palm of the hand, as necessary to fit thepart to the car.		10. The final step is to seal and dry the film edges with a hard card wrapped in a paper towel.